Electrist for Palm OS
Operators Manual
Download Purchase
- Interface
- Calculators:
- Other:
-
Ohm's Law/Watt's Law -
Resistor Value -
Series/Parallel R/L/C -
Unknown Value -
Voltage/Current Dividers -
Reactance -
Impedance -
Resonance -
Sine Conversions -
Decibels -
VSWR -
Delta/Wye(Delta/Star) -
Time Constant -
Conductor Size Selection -
Conductor Voltage Drop
- Display
- Series: Calculate resistance, inductance, or capacitance in series arrangement
- Parallel: Calculate resistance, inductance, or capacitance in parallel arrangement
- Resistance: Calculate resistance in series or parallel arrangement
- Inductance: Calculate inductance in series or parallel arrangement
- Capacitance: Calculate capacitance in series or parallel arrangement
Use the menus described above to select whether you want to calculate a series or parallel circuit, and if it should be resistive, inductive, or capacitive.
(Hint: While it is probably a good practise to always make these your first steps when using this form, it can be done at any time - if you forget to select before entering values into the list you won't have to clear the form and start all over. Electrist will recalculate using the existing values in the list anytime you change the Display settings)
 |
 |
 |
 |
 |
 |
Write each value into the field at the very bottom of the form, tapping the Add button after each.
Each time a value is added to the list the resultant value is displayed at the top of the form.
To remove a value highlight in the list by tapping it, then tap the Remove button.
